GC2410 Temp Gauge Not Moving After Start

   / GC2410 Temp Gauge Not Moving After Start #11  
it should be running around 180F . if it runs cold it will wear the cylinders out a lot faster. the clearance will not be up to specs when running too cold or too hot. hares a cheap tool that can be handy, point it at the top of thermostat housing to get a good reading of the temp. https://www.harborfreight.com/121-infrared-laser-thermometer-63985.html
 
   / GC2410 Temp Gauge Not Moving After Start
  • Thread Starter
#12  
This is solved I hope. Was the temp sender connection. I checked to make sure the gauge was good by grounding it(went to the top like you and the Agco mechanic said it would). Then I cleaned the connection and made aure it was snug after checking upper (141f) and lower(121f) hoses were flowing through.
Now it registers the temp above C. Will test it full tomorrow.

Dealer mechanic was also very helpfull.

I believe the root cause was the belt flapping around because it was so loose.
20240507_120334.jpg
20240507_120327.jpg
20240507_120244.jpg
 
   / GC2410 Temp Gauge Not Moving After Start #13  
Glad your problem is fixed. good deal
 

Tractor & Equipment Auctions

2014 VOLVO VHD DAYCAB (A50854)
2014 VOLVO VHD...
2025 78in Dual Cylinder Hydraulic Grapple Rake Skid Steer Attachment (A50322)
2025 78in Dual...
2016 CATERPILLAR CT660 TRI AXLE DUMP TRUCK (A51222)
2016 CATERPILLAR...
2014 MACK GU (GRANITE) (A50854)
2014 MACK GU...
2015 Chevrolet Silverado (A50323)
2015 Chevrolet...
2014 VOLVO VHD DAYCAB (A50854)
2014 VOLVO VHD...
 
Top