getting a mf 4345 and looking for some feedback.

   / getting a mf 4345 and looking for some feedback. #21  
Re: getting a mf 4345 and looking for some feedbac

Hey Plumboy!/forums/images/graemlins/grin.gif How about an update on the 4345.
Did the dealer fix the problems/forums/images/graemlins/frown.gif you were having? and if he did, what did he say caused them?

You have not posted in a while and I;m hoping that it's because your to busy enjoying your new tractor/forums/images/graemlins/cool.gif and not because you have'nt gotten it back yet/forums/images/graemlins/mad.gif.

Nailerguy
 
   / getting a mf 4345 and looking for some feedback.
  • Thread Starter
#22  
Re: getting a mf 4345 and looking for some feedbac

I've had it back for about a week.I'm not sure what to do with it and the dealer.They replaced a sensor on the engine changed the hyd fluid and cleaned the screens.I told them I was going to buy them a funnel so they dont waste hyd oil by spilling it all over the rear of these tractors.The code still flashes when you start it sometimes but goes away when you hit the clutch or gas pedal.It was coming on after about an hour of working,so I'll try to work it this coming weekend weather permitting.Its got me and them puzzled.One other thing,the hour meter only pops up when you start it and when me and the salesmen was going over it it read 0005.I said this thing has 5 hours on it but he assured me that it was only a 1/2 hour.Wrong. /forums/images/graemlins/mad.gif
Thanks for asking nailerguy,I'm sure it will work out.Been following the polebarn threads cause that's my next project.
/forums/images/graemlins/laugh.gif
 
   / getting a mf 4345 and looking for some feedback. #23  
Re: getting a mf 4345 and looking for some feedbac

Thanks for the reply Plumboy, that does sound quite strange, almost like there is some kind of short or feedback in the wiring harness. Anyway like you said, it will all work out in the end.

Funny about the pole barn, I am also getting ready to build one, not to big 24' X 36' . Someplace to put the tractor and all the implements in the dry and out of the elements.

Anyway good luck and keep us posted on the 4345. /forums/images/graemlins/cool.gif

Nailerguy
 

Tractor & Equipment Auctions

2003 International 4300 Flatbed Truck w/ Liftgate - Inoperable - 7.6L DT466 Diesel Engine (A51039)
2003 International...
2022 FORD F-150 LARIAT CREW CAB TRUCK (A51406)
2022 FORD F-150...
MAXUM M-1000 TRIPLEX PUMP POWERED BY 3412 CATERPILLAR ENGINE (A50854)
MAXUM M-1000...
2014 Gillig Transport Bus (A50323)
2014 Gillig...
DMI 3200 Side Dress Bar (A50514)
DMI 3200 Side...
2016 Ver-Mac S/A Towable Trailer Message Board (A49461)
2016 Ver-Mac S/A...
 
Top