golf cart top and quick attach and lights and tool boxes and hydraulic top link

[goneblue]

Got a golf cart top and some steel tubing for less than $100 and welded up a top for my G3038H and it fits in a regular single car garage. The way I welded the frame
makes the top come on and off and the rops pulls back and have about 1 inch clearance to get in my garage. added a hyd. top link and gives me the same travel
with a box blade both directions. just did the 50 hour service, found a few loose bolts, but went pretty easy. Got a quick release from harbor freight and spent a day
going over their welds and adding some supports and put 1 1/2" steel bushings on grade 5 bolts so there is no slop in the lower arms. did the 1 1/2" bushings on my
bush hog, box blade and landscape rake. all pick up very easy and quick and no slop at all . took quite a bit of custom fitting but was worth it.

 

[Guesseral]

Nice job on the Golf card lid. Two tool boxes that just isn't fair!

 

[ruffdog]

Yep, nice job. Around here, any permanent modifications (welding, holes) to a ROPS makes it very hard to trade or sell. They figure a new ROPS replacement into the cost most times.

 

[Underdog57]

Nice work goneblue, good looking Rig!! :thumbsup:

 

[Tarnold]

Nice work goneblue, good looking Rig!! :thumbsup:

Love those mirrors , do they vibrate very much?

 

[goneblue]

The mirrors are very stable. Very nice when grading a road

 

[lostcreekranch]

Got a golf cart top and some steel tubing for less than $100 and welded up a top for my G3038H and it fits in a regular single car garage. The way I welded the frame makes the top come on and off and the rops pulls back and have about 1 inch clearance to get in my garage. added a hyd. top link and gives me the same travel with a box blade both directions. just did the 50 hour service, found a few loose bolts, but went pretty easy. Got a quick release from harbor freight and spent a day going over their welds and adding some supports and put 1 1/2" steel bushings on grade 5 bolts so there is no slop in the lower arms. did the 1 1/2" bushings on my bush hog, box blade and landscape rake. all pick up very easy and quick and no slop at all . took quite a bit of custom fitting but was worth it.

What paint did you use? Seems to match the LS blue very well?

Sent from my iPad using TractorByNet

 

[goneblue]

check out a thread I posted here on the sherwin williams paint code for LS blue

 

[lostcreekranch]

check out a thread I posted here on the sherwin williams paint code for LS blue

Found it. Thanks! About how much was the gallon you bought at SW?

Sent from my iPad using TractorByNet

 

[goneblue]

It is industrial quality and was about $100 per gallon, but if
you can set up an account with them it saves about 50%. It has not
rubbed off the bush hog or boxblade and you know what they go through.
It is much better than I expected.