My name is Bob in IL. I just purchased a 90s modle Mahindra 485DI with a loader. Very nice little tractor , with very strong engine and clutch! My question today is the wiring on it is a bit rough! All the lights and turnsignals are broken/gone! Not really concerened about that , my problem is the charging system! I spoke with Dan in Texas ,i belive, service manger there , he says the yellow/green tracer wire at the alt. should have 12 volt with key on, I have no voltage. I had alt. checked at NAPA, and it put out 10 volt, so I ordered a new alt, but i was hoping to find a wiring diagram on the 485 , so I can by pass / remove all the lights and etc, and get the yellow /green wire to put out 12 volt!! Any thoughts would be great!!! Thanks! Raining here!!! too much!!
Good morning form
- Thread starter bobrl
- Start date
- Views: 406
mguitas
Super Member
- Joined
- Aug 22, 2011
- Messages
- 8,080
- Location
- Schuylkill County Pennsylvania
- Tractor
- Massey Ferguson 1423 Hydrostat
:welcome:to the forum.