I've got a standard manual grease gun with a short pipe (~1") and want to replace it with longer one. I've tried to remove it, but it is stuck. I decided to either get 2 small nuts and twist them on against one another then use a wrench on the inner one to unscrew pipe or get a connecting nut to just add the extension. I can't determine the thread size on the pipe. Closest I've come to getting a match is an M10-1.0, but even that binds up after about 3 turns. Anyone know what the thread size is on standard grease gun fittings?
Grease gun thread size?
- Thread starter PETDOC
- Start date
- Views: 1572
TractorGuy
Elite Member
- Joined
- Sep 15, 2013
- Messages
- 4,616
- Location
- N. FL
- Tractor
- John Deere 4310 CUT, Ford New Holland 575E Industrial Backhoe, John Deere F725 Front Mount Mower
1/8" NPT
DLTTrekkers
Veteran Member
And its taper !
WranglerX
Super Member
RickB
Super Star Member
- Joined
- Sep 18, 2000
- Messages
- 15,190
- Location
- Up the road from Dollar General WNC
- Tractor
- Just a Scag
NPT is tapered by definition.
DLTTrekkers
Veteran Member
Thanks RickB...never to old to learn !