Two questions actually. My 4510 has a grease port under my rubber floor mat. The front end loader column bolts thru the mat and I cannot lift it far enough to access the zerk. It is thick rubber but I can cut it with a rubber knife and that should give enough lift or other ideas.
The other thought is I think I can reach the zerk from underneath the tractor but the zerk is angled the wrong way. I could replace it with a straight zerk but the question is- are the zerks sae threads or are they metric threads? Thanks again,
The other thought is I think I can reach the zerk from underneath the tractor but the zerk is angled the wrong way. I could replace it with a straight zerk but the question is- are the zerks sae threads or are they metric threads? Thanks again,