Head Replacement

[itcametopass]

I have a YM2210 that I recently replaced the head that had become cracked due to overheating. I replaced it with a rebuilt unit I ran down. I ran it for about two hours finish mowing & put it up. The Temp for most of the time was in the 190 - 205 range with the new temp gauge I installed. When I started it again I noticed a bit of smoke leaking from between the head & block. /forums/images/graemlins/confused.gif I ordered another head gasket to replace the new one I just put in two hours of running ago.

I want to confirm the torque for the head bolts and see if anyone has any other ideas of things I need to look at when I take it down again.

Once more, Thanks for the help in advance.

 

[Egon]

Warped head and bolt tightening order.

Egon

 

[itcametopass]

The replacement head was supposed to be in good condition. What is the correct bolting order? I followed a tightening pattern. I want to make sure it was the correct one.

Thanks