Help with Jinma 244E

[slugg]

Hi
I have a problem with my Jinma 244E. It has started to leak oil. There is a leakage att the left side if the engine and in the middle, just behind the fule filter. Can someone help me?

Best regard slugg

 

[Muhammad]

Welcome to TBN.

 

[creekbend]

There is a forum here on TBN in regards to Chinese Tractors. Perhaps you might get more assistance by posting your thread on that forum. Good Luck. BTW:welcome:

 

[Briana03]

WELCOME to TBN

I moved your thread to the Parts/Repairs Forum.

 

[slugg]

Okey, thanks!!!

I found the leak, I will upload some pictures that shows the problem, I hope for warranty repair. Used the machine less than 35 h.

/slugg

 

[slugg]

Hi
Now I have uploaded some pictures to Pixbox. I have taken off Diesel pump. What has sealed the hole from the factory was a mixture of epoxy and chemical metal from the plastic padding. Now I'm wondering to plug the hole with a plug made ​​of brass. Or are there any suggestions from you on the forum.

Pictures See the link below.

Pixbox: sluggs album "Jinma 244E"

Best regards Slugg

 

[zonta223]

You may have a lot more luck posting your question here
Chinese Tractors - TractorByNet.com
There are good dealers and lot of Jinma owners only to happy to help

 

[slugg]

Okey thanks, I will

 

[KYErik]

Is it a pressurized leak (spraying) or just a slow leak?

How much clearance is there between the hole and the injector pump housing?

Here are some options that come to mind:
1. brass plug
2. install tapered neoprene plug (it would be similar to an oil proof cork stopper), then use a flat metal strap to hold it in place (use the threaded hole which is about 2 inches below the leak to secure the strap).
3. clean it well and mix up some JB weld epoxy and put in the hole
4. carefully stuff a small bit of rag down the hole and then try to tap it for a similar sized bolt. Removing the rag and using a magnet should pull out the metal shavings.

 

[slugg]

Hi
The distance between the pump and the hole is about 12 mm or half inch. I can not access to do a thread in the hole. But I myself have thought of doing a plug made ​​of brass. 0.02 mm larger than the hole, so I can knock it there and lock with locktite or similar.

/ Slugg

 

[slugg]

Hi
Now I have fixed the problem with the oil. I sealed the hole with a brass plug. So now the tractor is like new again. I also thank the manufacturer in China for the great support by e-mail.:thumbsup:
/Slugg