milkman
Elite Member
- Joined
- Sep 22, 2001
- Messages
- 3,625
- Tractor
- BX2200, BCS 735
That is awesome, wish I knew how to do that.
Help with sickle bar ID
- Thread starter SwingOak
- Start date
- Views: 3470
-
- Tags
- sickle bar mower
OP
SwingOak
Silver Member
- Joined
- Jan 31, 2011
- Messages
- 241
- Tractor
- '65 IH Cub Lo-Boy, '13 Kioti DK50SE HST, '20 Kioti RX7320
I'm working on modeling the hinge now - cast parts are always tricky, and it's large enough and oddly shaped so it's difficult to measure. So once I model the actual part I can design a weldment as a replacement if it is ever necessary.
I've been painting the parts with Valspar Cub Cad yellow because I have a few rattle cans on the shelf, and just found out Tractor Supply isn't selling the Valspar paint any more. I'm going to check a hardware store nearby that might carry it. Seems like just about everything at TSC is made in China, and most of it is cheap junk too. I am increasingly unhappy with TSC, but that's another topic...
I've been painting the parts with Valspar Cub Cad yellow because I have a few rattle cans on the shelf, and just found out Tractor Supply isn't selling the Valspar paint any more. I'm going to check a hardware store nearby that might carry it. Seems like just about everything at TSC is made in China, and most of it is cheap junk too. I am increasingly unhappy with TSC, but that's another topic...
