My L105E loader has 3 grease zerks on the left side that I can find. On the right side, I only see 2. In the attached photo of the right side, the fitting near the top-center of the photo, holding the hydraulic lines, is where there is a grease zerk on the left side. Should I try removing that fitting w/ an alan wrench, to see if there is a zerk behind? (I don't dare remove it without someone telling me it will not be a problem.)
Hidden grease fitting?
- Thread starter TVZ
- Start date
- Views: 1236
oosik
Epic Contributor
No - that hex bolt holds the hydraulic line stand off. I sure wouldn't think there is any type of zerk behind that. Maybe somebody with an MF in that model will come by with an answer. Isn't its location shown in your FEL Owners manual?
I figured it out! That zerk is on the other side of the arm!
WranglerX
Super Member
Funny... I made up post to look on other side, but some how missed actually posting it..... Must have been old age mental fog...
