3-Point Hitch Home made Forklift

[Nutman]

beenthere

I hope I did this right so you can attach the pictures to this thread.
If anyone else wants to know what were talking about here goes. I asked this kind man if he would send me some more pictures of his 3 pt forklift and he said he would. This is not really a forklift but it will lift what I need to do the job. I'm new to this forum stuff so he's helping me get a thread started so we can all see the pictures.

Thanks so much
Nutman

 

[beenthere]

:welcome: nutman

Glad to put some together. May just have to take some more tomorrow if not enough.
These pics show the solid steel bar (1 1/4" I am sure) welded across the fork frame for the lower hooks of the iMatch and the two steel plates at the top to sandwich the top pin for the upper hook of the iMatch.

 

[beenthere]

Then with the hyd. top arm, the fork tips can be tilted up/down easily for sliding under a pallet.

 

[Nutman]

beenthere

Thanks again for all the pics. I see it also hooks up in the front of your tractor.

nutman

 

[beenthere]

Yes, nutman.
It comes from Deere set up to quicktach to the FEL.