Mrsig
Gold Member
Got them the other day very easy to install I just had to buy a new 1/2" drill bit.
Hooks on FEL Bucket
- Thread starter Mrsig
- Start date
- Views: 33353
Roadworthy
Elite Member
Hooks on a bucket are really handy. I installed mine in line with the hydraulic actuators.
Xfaxman
Super Star Member
- Joined
- Feb 8, 2013
- Messages
- 12,883
- Location
- Guthrie, OK
- Tractor
- Toolcat 5610 G - Bobcat V417 - TORO+Loader
Only have one hook on my bucket and the hole was already there:
Thomas
Epic Contributor
- Joined
- Apr 6, 2000
- Messages
- 30,964
- Location
- Lebanon,NH.
- Tractor
- Kubota B2650HSD w/Frontloader & CC LTX1046 & Craftman T2200 lawn mower.
WranglerX
Super Member
Simply made chain slots from 2x2x1/4 angle iron...
ROUSTABOUT
Elite Member
- Joined
- Jan 30, 2008
- Messages
- 3,140
- Location
- Luther Willis Hill, AR
- Tractor
- Pettibone, Ford, Massey Ferguson, International, JD, David Bradley, home mades
Bend your bucket picking up in center. Corner is stronger.Looks good
Just being curious why not center hook??
repete
Veteran Member
I reinforced the bucket top edge and installed hooks at ends and center.
I use the ends (corner) if I am lifting something of insignificant weight and lift from the center any heavy objects. When I lift from the center I do not twist my loader frame or tip my tractor.
I use the ends (corner) if I am lifting something of insignificant weight and lift from the center any heavy objects. When I lift from the center I do not twist my loader frame or tip my tractor.
WranglerX
Super Member
MY center mount ring on bucket is for holding things in bucket... I put a dedicated pulling ring on front of tractor chassis to do serious pulling..... Only negative is access to ring with bucket in the way...
bdhsfz6
Elite Member
- Joined
- Apr 11, 2015
- Messages
- 3,095
- Location
- Northeastern Pennsylvania
- Tractor
- Kubota MX5800 HST & L6060 HSTC Formerly L6060 HST B7100 HST, L2550, L3010 HST, L3430 HST
Nice wide flanges. Less likely to bend the bucket top plate.
hslogger
Platinum Member
I have three hooks. always have always will. Hooks on the side for light work.
hook in the center for HEAVY work. It doesn't do the mechanism any good to reef the heck out of one side.... plus you can get your tractor airborne.
Welded on or bolted on, is the best. I see the guy with the grab hook attached to a hole with some hot link or shackle. I know it works, but it's a bit awkward. Buddyamine did that to a small tractor and it's kind of a pain in the butt compared to a fixed sold mount.
hook in the center for HEAVY work. It doesn't do the mechanism any good to reef the heck out of one side.... plus you can get your tractor airborne.
Welded on or bolted on, is the best. I see the guy with the grab hook attached to a hole with some hot link or shackle. I know it works, but it's a bit awkward. Buddyamine did that to a small tractor and it's kind of a pain in the butt compared to a fixed sold mount.
