frank_f15
Super Member, Rest in Peace
HELP settle a discussion, how many hours before you re-grease your RFM
Rear Finish Mower hours bet. greasing RFM
- Thread starter frank_f15
- Start date
- Views: 1128
Cyberroc
Silver Member
- Joined
- Jun 4, 2008
- Messages
- 168
- Location
- Mid-Michigan Area
- Tractor
- 20th Anniversary Edition KIOTI CK35 Synchro Shuttle | KL130P FEL | KB2475 BH
Been a while since I haved owned/greased one, so my info maybe outdated...
We greased the RFM/FEL/BH or anything that was in service for a full day, two half days, or after 10 hours of use, which ever came sooner.
From what I can remember it was hard to keep track so it ended up being pretty much after every use...
We greased the RFM/FEL/BH or anything that was in service for a full day, two half days, or after 10 hours of use, which ever came sooner.
From what I can remember it was hard to keep track so it ended up being pretty much after every use...
coveredbridge
Gold Member
The manual for my Woods RFM says axles and pivot pins every 8 hrs, spindles and drive shaft u-joints every 24 hrs. I try to stick pretty close to that, but sometimes I don't keep up with the axles and pivot pins. I have about 680 hrs on the mower in the 15 yrs since I bought it new and the only thing I ever replaced was one axle sleeve. Still running the original belt.
I hate greasing more than just about anything. It's such a messy job. I just greased my Woods, and I ran out of grease on the last fitting. Had to change tubes - grease everywhere. I just hate it.
I hate greasing more than just about anything. It's such a messy job. I just greased my Woods, and I ran out of grease on the last fitting. Had to change tubes - grease everywhere. I just hate it.
Soundguy
Old Timer
- Joined
- Mar 11, 2002
- Messages
- 51,575
- Location
- Central florida
- Tractor
- RK 55HC,ym1700, NH7610S, Ford 8N, 2N, NAA, 660, 850 x2, 541, 950, 941D, 951, 2000, 3000, 4000, 4600, 5000, 740, IH 'C' 'H', CUB, John Deere 'B', allis 'G', case VAC
frank_f15 said:
I check the oil level in the 4 gearboxes, and regrease my batwing before every use.. though not more than once per day, if I happen to use it more than once that day.. etc.
it's 15 minutes well spent..
soundguy
OP
frank_f15
Super Member, Rest in Peace
coveredbridge said:
Will have to agree it is a messy job and i guess i was right on as i usually grease it about every 8 hours of use. not used in dusty condiions or sand areas, just northeastern grass.
EddieWalker
Epic Contributor
I grease it before using it. If I run it for hours and hours, or just an hour, it doesn't matter. The same is true with everything that I have. I grease it before using it that day.
Eddie
Eddie
