Ginormous
Gold Member
Pretty much said in the title... How does JD "unsynchronized sliding gear" compare to Yanmar Powershift?
How does JD "unsynchronized sliding gear" compare to Yanmar Powershift?
- Thread starter Ginormous
- Start date
- Views: 2076
California
Super Star Member
- Joined
- Jan 22, 2004
- Messages
- 16,136
- Location
- An hour north of San Francisco
- Tractor
- Yanmar YM240 Yanmar YM186D
Even worse than an automobile transmission that has usually has synchronizers to make gear engagement smooth.
I assume JD "unsynchronized sliding gear" is the same as the MT Yanmars. Assuming it is the same, it means a full stop before any gear change. (Or else horrible expensive-sounding grinding). It can't be shifted in motion. Or even standing, after the inertia of a mower etc gets the gears spinning.
Some people might say you can double clutch it but that assumes constant speed gliding along by inertia on asphalt, not lurching over native ground.
Powershift is vastly better. Just shove the gear lever into the intended gear and it takes care of the rest. Clutching is a good idea to ease stresses but it isn't essential.
I assume JD "unsynchronized sliding gear" is the same as the MT Yanmars. Assuming it is the same, it means a full stop before any gear change. (Or else horrible expensive-sounding grinding). It can't be shifted in motion. Or even standing, after the inertia of a mower etc gets the gears spinning.
Some people might say you can double clutch it but that assumes constant speed gliding along by inertia on asphalt, not lurching over native ground.
Powershift is vastly better. Just shove the gear lever into the intended gear and it takes care of the rest. Clutching is a good idea to ease stresses but it isn't essential.
rmully
Gold Member
:thumbsup: Powershift is very smooth and effortless almost like shifting from low to high on a car.
