BXMMCC
Silver Member
- Joined
- Jul 7, 2003
- Messages
- 179
- Tractor
- Kubota BX2200
I'm gonna put a strip of horse mat on my rear blade. How far should it stick out beyond the normal cutting edge?
How far should it stick out
- Thread starter BXMMCC
- Start date
- Views: 763
slowrev
Elite Member
What is this setup going to be used for ? Snow removal ?
ronjhall
Super Star Member
BXMMCC
I added a much heavier rubber cutting edge to my 6 1/2' Curtis blade. I originally had it sticking about 5". The rubber rolled back almost 45 degrees. I then changed the mounting so that rubber stuck out about 2". By mounting the rubber in front of the steel cutting edge. I'm happy with this setup. /forums/images/graemlins/smile.gif
Here is a link to the thread with pictures that TresCrows started on his plastic edge. Click Here
I added a much heavier rubber cutting edge to my 6 1/2' Curtis blade. I originally had it sticking about 5". The rubber rolled back almost 45 degrees. I then changed the mounting so that rubber stuck out about 2". By mounting the rubber in front of the steel cutting edge. I'm happy with this setup. /forums/images/graemlins/smile.gif
Here is a link to the thread with pictures that TresCrows started on his plastic edge. Click Here
markie61
Veteran Member
- Joined
- Mar 31, 2001
- Messages
- 1,362
- Location
- Northern Virginia
- Tractor
- 2019 Rural King RK55HC with Loader & Backhoe; 2001 New Holland TC40D with Loader
I find that the rubber edge sticking out 2" from the backing plate is good. Any more than that and it will roll/bend under pressure. I was worried that it would wear down fast, but there is very little wear after a full season of plowing a couple paved and several gravel drives.
Mark
Mark
