How to get started reloading ammunition
- Thread starter rtimgray
- Start date
- Views: 9936
charlz
Elite Member
I like that set up a lot, I just might have to copy it 
jack707
Veteran Member
get a Lee less expensive a pretty good at reloading also.
Soundguy
Old Timer
- Joined
- Mar 11, 2002
- Messages
- 51,575
- Location
- Central florida
- Tractor
- RK 55HC,ym1700, NH7610S, Ford 8N, 2N, NAA, 660, 850 x2, 541, 950, 941D, 951, 2000, 3000, 4000, 4600, 5000, 740, IH 'C' 'H', CUB, John Deere 'B', allis 'G', case VAC
i know some people hate lee stuff. ( usueally the smurfs )... but i tell ya. the gun don't seem to notice much whether the die set came out of a yellow, red, clear red, or green case...
the old grind
Elite Member
- Joined
- Jul 21, 2012
- Messages
- 4,412
- Location
- Mid-Michigan
- Tractor
- NH T-1520 HST, NH TC33DA HST, Case DX26 HST, .Terramite T5C, . NH L785
Depending on patience or perhaps productivity, and discounting auto feeders etc, a press is a press, is a press. As for dies, different brands/lots will be found within tolerance but one possibly a better fit for a particular chamber's tolerance. It's not what you have, it's what you do with it. (Those who go beyond a few reloads with a batch of cases know how they got that far.)
If you gather gear in batches, from yard/estate sales etc, you're bound to end up with extra die sets for a caliber. There will be ones that you never use, and maybe ones preferred for certain guns (chambers). At that point, box color can become like "Go Packers!" or a Ford/Chevy thing.
Those extra single stage presses can be designated for decapping, swaging primer crimps, case forming steps, etc. There's no substitute for room to set 'em up.
btw: Lee tools I won't load without after ~10yrs: Ram Prime, Univ de-capper, case trimmers/pilots, 1-flute neck chamfer tool, zip trim, collet neck sizers (say a dozen calibers). While I'm at it, SS pins to tumble brass 'wet'. (U/Sonic & vibrating methods are hungry and messy (dust, chemicals vs soap & water)..) :stirthepot:
If you gather gear in batches, from yard/estate sales etc, you're bound to end up with extra die sets for a caliber. There will be ones that you never use, and maybe ones preferred for certain guns (chambers). At that point, box color can become like "Go Packers!" or a Ford/Chevy thing.
Those extra single stage presses can be designated for decapping, swaging primer crimps, case forming steps, etc. There's no substitute for room to set 'em up.
btw: Lee tools I won't load without after ~10yrs: Ram Prime, Univ de-capper, case trimmers/pilots, 1-flute neck chamfer tool, zip trim, collet neck sizers (say a dozen calibers). While I'm at it, SS pins to tumble brass 'wet'. (U/Sonic & vibrating methods are hungry and messy (dust, chemicals vs soap & water)..) :stirthepot:
jack707
Veteran Member
I have a lee press and RCBS dies.
