Ed of all trades
Elite Member
I understood that most pantagraphs were set up so the template was up above the torch and a pin or magnetic rotor followed the template. Ed
How to hold a Template when using a Pantagraph (duplicator)
- Thread starter sweettractors
- Start date
- Views: 3764
Luke'sScreenName
Elite Member
- Joined
- Mar 1, 2015
- Messages
- 3,710
- Location
- Lakes Region, NH
- Tractor
- Kubota MX4800 with BH-90X hoe; Hustler FastTrack 48; B3300SU (sold); 1969 Case 680B CK (sold)
This is what I use for woodworking. Buy Woodworking Tape 2" x 5 ' at Woodcraft.com
aarolar
Platinum Member
Maybe ask this guy?
Big Barn
Super Member
- Joined
- Aug 20, 2013
- Messages
- 7,047
- Location
- Victoria, B C
- Tractor
- More than 40 over the years. Ten at any one time. Mostly Ford and New Holland
Mysfyt
Platinum Member
Like Ed said, the one I had you would mount a metal template above and a magnetized rotor would follow it. There were one or two threaded rods that would require a hole in the template. What kind of pantograph do you have? Picture would help.
OP
sweettractors
Advertiser
The 3M contact glue, hot glue gun and automotive grade double sided tape work pretty good. I tried velcro with little success. Have been busy in the business lately, however, I will get a pic of the project posted shortly.. Ken Sweet
