sanmigmike
Bronze Member
Have a medium size Husky air compressor, on wheels. Didn't like bending down to drain the tank so I bought a HFT auto drain kit. Got a 90 degree elbow and started putting it on. Got to the point of cutting the hose from the tank to the regulator to put the "T" connection in and I can't get the supplied connector into the Husky hose, the Husky hose has a much thicker wall than the HFT hose. Thinking of replacing the Husky hose but so far I cannot figure out how to replace the Husky hose, getting it off at the tank is not a problem but getting it off the regulator switch is something I just cannot figure out. Any ideas out there?
