hydraulic couplers what do i need?

   / hydraulic couplers what do i need? #1  

john m

New member
Joined
Jan 17, 2011
Messages
22
Location
Inverness,FL
Tractor
cub cadet 149
i have been trying to find a 7/8 ORB fitting for my haldex pump to run my loader. i want to use 37 jic reuseable fittings on the hoses for the pump to the valve and reservoir. i came across these fittings but they are listed as #14 SAE is that the same as fractional values? i want to run 3/4 Inch supply hoses on the pump and 3/8 off the working ports. any help on this.
 
   / hydraulic couplers what do i need?
  • Thread Starter
#3  
i have several pages on that site book marked, but that is the ORFS fittings. my pump is 7/8 ORB Female ports.
 
   / hydraulic couplers what do i need? #4  
i have been trying to find a 7/8 ORB fitting for my haldex pump to run my loader. i want to use 37 jic reuseable fittings on the hoses for the pump to the valve and reservoir. i came across these fittings but they are listed as #14 SAE is that the same as fractional values? i want to run 3/4 Inch supply hoses on the pump and 3/8 off the working ports. any help on this.

The #14 refers to 16ths." in size. #14 = 14/16 = 7/8. #12 is 3/4, etc. ORB fittings use same thread size and pitch as 37 degree (JIC) flare.
 
   / hydraulic couplers what do i need?
  • Thread Starter
#5  
okay, now i understand. i`m going to call them tomorrow and see what i can get, but i need to do some measurements first. thanks
 
   / hydraulic couplers what do i need? #6  
i have been trying to find a 7/8 ORB fitting for my haldex pump to run my loader. i want to use 37 jic reuseable fittings on the hoses for the pump to the valve and reservoir. i came across these fittings but they are listed as #14 SAE is that the same as fractional values? i want to run 3/4 Inch supply hoses on the pump and 3/8 off the working ports. any help on this.

The dash sizes do refer to 16ths of an inch, but please note that these are nominal sizes, and NOT thread dimensions.

Just as 1/2" NPT (pipe thread) doesn't have a thread OD of 1/2" neither does 1/2" JIC or #8 SAE (O-Ring Boss).

For a break down of nominal sizes, dash sizes, and actual thread dimensions, please see the Fluid Port Size Charts at DiscountHydraulic Hose.com
 
   / hydraulic couplers what do i need?
  • Thread Starter
#7  
i`ll call you and see what you have.
 

Tractor & Equipment Auctions

2017 Ram 5500 Chassis Crew Cab Reading Service Truck (A52377)
2017 Ram 5500...
2019 GEHL R105 WHEELED SKID STEER (A51242)
2019 GEHL R105...
FORREST RIVER CHEROKEE CAMPER (A52472)
FORREST RIVER...
2008 ATOKA TRAILER & MFG. ATOKA TRAILER & MFG. (A53843)
2008 ATOKA TRAILER...
Auger for full size skid steer (A53421)
Auger for full...
2001 Dodge Ram 3500 4x4 Knapheide Flatbed Truck (A51692)
2001 Dodge Ram...
 
Top