Hydraulic pump adapter

[284 International]

I posted this same question in the parts section, but realized I may have better luck here.

I need to couple an SAE A (11 spline 3/4" male connector) pump to my tractor, which has an SAE B (13 spline 7/8" female connector) end.

What is the best way to do this? I can't find any direct adapter for this configuration.

 

[J_J]

Try here.

Lovejoy, Inc. : Products : Couplings & Power Transmission : Jaw Type Couplings : L Type

 

[284 International]

Thank you for that site, J_J. I can't seem to find specifications or part numbers for splined connectors for these couplings. Are they special order items?

 

[J_J]

Did you look through the PDF on the tight side of the page?

L Type Hub - Spline Bore UPC Number Selection Table

Give them a call and ask if the spline chart is what you need.

 

[284 International]

Sorry, I should have been specific in what I couldn't find. It appears that there are only female couplings, no male ended connections, but I'll find out more tomorrow. Thank you, again.

 

[Leejohn]

I think I know what you are looking for, it's more like a sleeve. I have seen them and have been trying to think where I have seen them used on. Hang in there for a little while.

 

[284 International]

Leejohn, a sleeve-type adapter would work, or a Lovejoy coupling with a male splined end. Thanks.