:confused2:
Hello everyone, i'm in some trouble, long story short, leaky carb,change gasket, easy fix, no, bowl bolt strippped tapped it broke the cast inside here main needle goes, locate new carb 3 wks later, not a kohler, but a walbro,install it,fires up, it has 3 adjusters on it, cant seem to dial it in, its a k321aqs motor, the new carb is off a newer motor with identical #'s however the # inside the carbs are different, the old is 30 m and the new is 60 m. im also concerned about running lean and blowing up my motor. one last ? there is a aluminum gasket between the valve cover and the head, are they reusable, or can i make a gasket and add to the aluminum one. turned out to be a long story. thanks guys
Hello everyone, i'm in some trouble, long story short, leaky carb,change gasket, easy fix, no, bowl bolt strippped tapped it broke the cast inside here main needle goes, locate new carb 3 wks later, not a kohler, but a walbro,install it,fires up, it has 3 adjusters on it, cant seem to dial it in, its a k321aqs motor, the new carb is off a newer motor with identical #'s however the # inside the carbs are different, the old is 30 m and the new is 60 m. im also concerned about running lean and blowing up my motor. one last ? there is a aluminum gasket between the valve cover and the head, are they reusable, or can i make a gasket and add to the aluminum one. turned out to be a long story. thanks guys
