Inner Tube Sealers

[nvkubot]

Remove valve stem core.Get a tight fitting piece of clear tubing that will slide over the valve stem.Drill 3/16" hole other side of stem in the tread.Get a can of great stuff foam.fill till the foam comes out of the 3/!6" hole.Valve stem will be on the bottom.make sure the tubing will not slide off can or valve stem or you will have a mess!Use hose clamps if needed.I did this to my pressure washer tires & I can stand on the tires,no more flats.

I'm going to try that on my wagon tires.

 

[drizler]

I was just reading another article the other day about how China pays a huge tariff to bring real rubber into their country so they are going to be adding coal dust and who knows what to further supplement the cheap crap they use in their already junk rubber and plastic products. We better figure out some clever ways to manage and this may well be one of them. Pretty sad isn't it? We had good rubber 80 years ago and look at the crap we have to put up with today.

 

[drizler]

I was just reading another article the other day about how China pays a huge tariff to bring real rubber into their country so they are going to be adding coal dust and who knows what to further supplement the cheap crap they use in their already junk rubber and plastic products. We better figure out some clever ways to manage and this may well be one of them. Pretty sad isn't it? We had good rubber 80 years ago and look at the crap we have to put up with today.