Rear Blade Is there a way to adust the lift arms to lift higher?

[allen in texas]

You are welcome and the TBN,r that had trouble with the linkage was MIDGALandscaper. Had a plow just like mine.

 

[Ed of all trades]

Thanks Ed, that worked I feel like an idiot.

We all have had to learn that at one time or the other, it was just your turn. Ed

 

[schmism]

You're right. I re-read the post and misunderstood. Thank you

I did a quick google search for a pic but didnt find one last night. A pic is worth a thousand words

you can see the addtional hole that allows you to raise the 3pt arms. the linkage on the back of my NH has 3 holes

 

[Don87]

I haven't purchased them yet, but I'm going to get a set of these: Tractor Quick Hitch Implement Ford Deere Kubota MF | eBay as my blade won't lift very high either.

 

[MtnViewRanch]

Ideally the boom on the rear blade should be parallel to the ground when the blade is setting on the ground. You need to use your top link to do this properly. To get addition lift from the 3pt hitch, the simplest thing to do is to put the top link in the lowest pin location on the tractor end. If your tractor has multiple clevis pin locations in the side links (lift links), then you can use the upper hole to get some additional lift. The problem for you with this is that I don't think that you have multiple holes in the clevises and therefore are limited to the top link pin location adjustment.

good luck