Looking at purchasing an ISEKI 1610 2wd. The guy says the hour meter is correct at 394 hr, and that it is 19.5 horses, comes with box scraper and loader. The tractor appears in good shape, I drove it and it runs fine and shifts ok ( the ratio is a little close compared to the hinmoto) Out the door for $6500. Am I getting burned or is this about average. Oh by the way this is in calif, any inputs or better ideas?
ISEKI 1610
- Thread starter BSKI
- Start date
- Views: 1573
fivestring
Veteran Member
Sounds a little high to me.
Less than 400 hours???? What do the pedals look like? What does the floorboard look like? What does the gear shift knob look like? If they look worn, there is more than 400 hours! With 709 hours, my pedals still are not worn down.
A box scrape (used) is about $150.
A new loader is about $2500.
That leaves $3850 for a 2wd tractor. Plus, I think that might be the 2 cylinder diesel.
My 4wd TU1700f (3 cyl. diesel) was $3900. It had 709 hours.
If you really like the setup, offer $4300, but give no more then $5000.
Good luck.
Less than 400 hours???? What do the pedals look like? What does the floorboard look like? What does the gear shift knob look like? If they look worn, there is more than 400 hours! With 709 hours, my pedals still are not worn down.
A box scrape (used) is about $150.
A new loader is about $2500.
That leaves $3850 for a 2wd tractor. Plus, I think that might be the 2 cylinder diesel.
My 4wd TU1700f (3 cyl. diesel) was $3900. It had 709 hours.
If you really like the setup, offer $4300, but give no more then $5000.
Good luck.
Tractors4u
Elite Member
- Joined
- Mar 10, 2002
- Messages
- 2,540
- Location
- Athens Alabama
- Tractor
- Deere 4310, Kubota L355, John Deere SST18 Spin Steer, 2006 Polaris Ranger
What brand of loader does it have on it? If it is a Bush Hog or Koyker then the cost of the loader is about $2500 - 2700. If it is a homebuilt loader those usually run about $1500 as an add on.
