So, new member! Bit of a tractor hoarder. Scored a cheap iseki Bolens g174 tractor and want to put an old loader I have laying around on it. Where would be best place to tap in? I have seen a few posts on here with the inlet and outlet tapped into the hydraulic manifold under the seat. Can anyone confirm this method is good aj explain it, probs the easiest for me but not sure if it’s correct way. Thanks everyone and help much appreciated, I’ve included picture of the tie In I want opinions on.
Iseki g174 front end loader plumbing
- Thread starter Jared11
- Start date
- Views: 1259
Roadworthy
Elite Member
That would seem to be the logical place. It is also possible to cut the pressure line anytime after the hydraulic pump and just use the loader as a kind of loop on the pressure line. Of course quick disconnects should be used so you can easily reconnect the lines if the loader is removed.
