hayphil
New member
Just bought this ISEKI 4270 tractor and have been unable to engage 4WD. Is there a particular sequence for engaging 4WD that I am unaware of?
Phil
Phil
Iseki4270
- Thread starter hayphil
- Start date
- Views: 814
GeneD14
Veteran Member
- Joined
- Jul 29, 2003
- Messages
- 1,458
- Location
- Tennessee
- Tractor
- Kubota B26 TLB, Allis Chalmers D17 series IV, Kubota ZG-23 Mower, Kubota ZD 1211, Kawasaki Mule 610, Stihl 361, Stihl 045 AV Super, and a Stihl 660 Ported and tuned
I had an agco tractor made by Iseki a few years back with the same problem. It was a new tractor and the lever to shift it into 4wd didn't want to move. The dealer said they were tight and would bind a little. He put one hand on the lever and one hand one the shaft the the lever is connected to and pushed in on the shaft while moving the lever. So from then on that is what I had to do to make it go into 4wd.
I don't know if you have the same issue, but you might try it. Good luck!
I don't know if you have the same issue, but you might try it. Good luck!
Here are some similar links:
