It' Finally Coming Down!! If This Keeps Up..

[Thomas]

Dave.
"I'll wait until tomorrow am to clear the drive."
See in early post you just couldn't wait to clean up.

Also thinking along the same lines in case it rain..sprinkle here sprinkle there not much..whew.

 

[bp fick]

Well, we got a good foot yesterday and I have awakened to an additional 6-8 inches this morning. Now the wind is howling out of the Northwest. It won't be nearly as pleasant as yesterday. I may have to go to town for donuts and coffee. Sitting at the big round table, usually all the world's problems get solved by those guys.

 

[Thomas]

BP.
"Now the wind is howling out of the Northwest. It won't be nearly as pleasant as yesterday."

Yep,when the wind kicks up fun-o-meter needle barely moves..more clothes,watch for falling snow clumps from trees.
....................................................................................................................

"I may have to go to town for donuts and coffee. Sitting at the big round table, usually all the world's problems get solved by those guys."

Least go for the coffee and donuts
We have "round table" in our area,and as you said "world's problems get solved" but acting on the answer...welllll thats something else.

Stay warm keep those snow banks push back.

 

[dave1949]

Dave.
"I'll wait until tomorrow am to clear the drive."
See in early post you just couldn't wait to clean up.

Also thinking along the same lines in case it rain..sprinkle here sprinkle there not much..whew.

Yes, I could see the temp was staying down and no sleet fell. I am better at working past midnight than I am getting up at 4am Now, if I can stay awake today, I have a sink to install.

Been to the hardware twice now collecting parts. It's stainless steel and the wall-mount faucet mounts on the backsplash. Not a lot of room (about 2 1/2" ) between the backsplash and wall behind it. I have a couple of drop-ear elbows that take 1/2" pipe on one end and 1/2" copper on the other. Going to screw those to the wall and hope my pipe nipple reaches out just the right length to be able to drop the sink in place through the countertop and have pipe threads sticking out to attach the faucet to. Ha Ha.
Dave.

 

[Thomas]

Dave.
Your kinda like the E-Bunny today..keeps going..keeps going.

I install somewhat of the same setup in our basement,those 1/2" braded flex hoses saved alot of time plus cussing.

 

[dave1949]

Dave.
Your kinda like the E-Bunny today..keeps going..keeps going.

I install somewhat of the same setup in our basement,those 1/2" braded flex hoses saved alot of time plus cussing.

I'll be using those. Trouble is, the faucet is actually held up by the pipes behind it. So I have to start with some solidly mounted pipe. I almost got it today. Just have to tweak the hot water pipe a bit to get a better lne up.
Dave.