Its up and running!!!!

   / Its up and running!!!!
  • Thread Starter
#11  
tractorErnie said:
Great to hear another yanmar was resurrected from the elements.
I just testored a 155 back top life last week.

I sold it the next day to someone who will take good care of it (I hope)

Do as california says and have that radiator fixed.
The correct mixture is 70% water 30% antifreze.

best wishes on your project
Ernie

I always hate selling something I rebuilt or restored. Cause you KNOW you would take care of it. But that person you are selling to...well, you just dont know.

What do 155D's in good shape sell for now? Average. I need to add it onto my policy.

Yea...going to fix that radiator. Told CA I am going to flush it again just to make sure and if it gets hot again then will take it and have it cored. Had to do that on my other tractor last year. But that took alot more work considering the top of the engine sits a foot higher than my head and I aint as spry as I useta be. :) And this one I can sit on a stool and work on it.:p

I have read in several spots about it being 40/60 but the 30/70 sounds more like what it should be like you said. Especially since there is no pump to move it around.

Dennis
 
   / Its up and running!!!! #12  
Goldchaser said:
...... What do 155D's in good shape sell for now? Average. I need to add it onto my policy......Dennis

Depending on hours and condition $3000-$3800 for a clean, low hour YM1300D. Yours being a domestic Yanmar, and especially equipped with the FEL, will bring considerably more ($5500. ??).

I find it strange that homeowners with 2+ acres will spend twice that for a box-store garden tractor. Even well maintained they seldom last for more that 6-7 years before a major overhaul, engine and deck replacement or replaced with another new GT. Your tractor, with simple scheduled maintenance, WILL go for decades.

Mark
 
   / Its up and running!!!! #13  
Goldchaser said:
...

I have read in several spots about it being 40/60 but the 30/70 sounds more like what it should be like you said. Especially since there is no pump to move it around.

Dennis

If you park it in an unheated area, just watch the temperatures in the winter. As I recall, a 30/70 mixture is good to about 7 deg F. NE Colorado got colder than that when I lived up there. Maybe global warming has changed that, though. :)
 
   / Its up and running!!!!
  • Thread Starter
#14  
reb said:
If you park it in an unheated area, just watch the temperatures in the winter. As I recall, a 30/70 mixture is good to about 7 deg F. NE Colorado got colder than that when I lived up there. Maybe global warming has changed that, though. :)

Nope....I think gorebal worming has skipped our area. ;) Last winter we had an average of about 20 degrees from Dec through Feb. It dipped into the -teens a few times but mostly stuck between 0 and 25 most of the winter. The winter before that was alot colder. We saw temps more than a few times down to the minus 30's :p And this year the cold weather came alot earlier than usual though the last week or so has been indian summer conditions with a few days up into the 70's. I am fully expecting a major snow storm by the end of the month, if not sooner. Last winter we had a blizzard thanksgiving day and the snow from that and subsequent blizzards stayed on the ground until I think April before the last of it finally melted. Normally we would have planted our millet in March but had to wait till near the end of April because of the melting snow and the ground staying too wet. We had geese living in our fields because of all the melt water so late in the spring.

I figure the 30/70 will be ok till about mid december. Then I will increase it to maybe 40/60, but I think I will get a block warmer and put it in. That way I can keep that in along with battery topoff charger and it will be ready to go anytime I need it. Plus, the garage where I will keep it can be heated if need be. It has its own furnace. So on snowy days I can also just kick the furnace on and it will stay nice and toasty. It will be warmer than our critters.:D
 
   / Its up and running!!!!
  • Thread Starter
#15  
mark777 said:
Depending on hours and condition $3000-$3800 for a clean, low hour YM1300D. Yours being a domestic Yanmar, and especially equipped with the FEL, will bring considerably more ($5500. ??).

I find it strange that homeowners with 2+ acres will spend twice that for a box-store garden tractor. Even well maintained they seldom last for more that 6-7 years before a major overhaul, engine and deck replacement or replaced with another new GT. Your tractor, with simple scheduled maintenance, WILL go for decades.

Mark

Thanks for giving me that figure. And plus it has the towed finish mower for it and a 3pt boom pole and I plan on getting another box blade and a grading blade for it. The box blade I have right now is for cat2 or bigger tractors. I dont think it will run my rough cut mower. I think that would be pushing it. Its a 72 inch.

WEll, i guess you can put me among those strange homeowners. :eek: I bought a craftsman yard tractor when we first bought this place. <sigh> I think we paid something like 1800.00 for it. :mad: And its been a problem ever since. We had to take it in 3 or 4 times for different things to be fixed. Right now its sitting by the back door with a flat tire and I just cant be bothered to mess with it any more. I think come spring I will get it all looking nice and running good and then sell it. Since I have my 155 and the finish mower, it would sit anyway.
 

Tractor & Equipment Auctions

2013 Ford E350 Box Truck (A47384)
2013 Ford E350 Box...
UNUSED FUTURE SKID STEER QUICK ATTACH SWEEPER (A51244)
UNUSED FUTURE SKID...
UNUSED FUTURE MINI SKID STEER PALLET FORKS (A51244)
UNUSED FUTURE MINI...
2008 CATERPILLAR 314CL CR EXCAVATOR (A51242)
2008 CATERPILLAR...
2020 CATERPILLAR TL1255D TELESCOPIC FORKLIFT (A51242)
2020 CATERPILLAR...
Case IH Farmall 75C (A52349)
Case IH Farmall...
 
Top