J-B Weld to fix IH emblem?

[Undercover]

Has anyone tried to fix the IH emblem on the grill screen with J-B Weld?
My posts on my 782 have been broke off.I had it hanging on with a small piece of wire.
It has stayed on but i still didn't like it.

 

[Bedlam]

Ive used the blue UTV silicone gasket maker once for an emblem and held real good and somewhat flexible

 

[Sam Mac]

I used 3M structural adhesive on my 1210 available at most auto body paint stores.

 

[Undercover]

I think the J-B weld is going to work.
I am using the slow drying stuff.First i glued 2 small bolt to the back of the emblem with the J-B weld.I let it dry overnight.I have been adding layers to it each day.I mix some up then place it on the back and run a hair dryer so it will smooth it out.I am going to keep adding layers until the back is almost filled in.Must be careful not to get any of the epoxy in the threads.
~~~~~~~~~~~~~~~~~~~~~~~
3235
1872
782
~~~~~~~~~~~~~~~~~~~~~~~

 

[Undercover]

I put the emblem back on to day and i was able to make it tight.I will revisit this post if it falls off.I will do so if it says on:laughing: