KennK
Silver Member
I have a John Deere 3320 purchased in 2006 with a mid mount mower (now removed) and the two rear hydraulic connectors that I assume drive the mower lift/lower.
I'm thinking about buying a Woodmaxx snowblower, and I'm wondering if I can disconnect & cap the rear hydraulic hoses that I think lift/lower the mid mount mower (the MMM is not on the tractor) and connect/use the rear hydraulic ports to rotate the snowblower's output chute.
The MMM lifts/lowers using a lever on the right side of the seat (next to the rear rocker arm lift/lower), so I assume it would be able to rotate the chute by pushing/pulling that same lever.
Any advice/insight you can give would be very helpful.
I'm thinking about buying a Woodmaxx snowblower, and I'm wondering if I can disconnect & cap the rear hydraulic hoses that I think lift/lower the mid mount mower (the MMM is not on the tractor) and connect/use the rear hydraulic ports to rotate the snowblower's output chute.
The MMM lifts/lowers using a lever on the right side of the seat (next to the rear rocker arm lift/lower), so I assume it would be able to rotate the chute by pushing/pulling that same lever.
Any advice/insight you can give would be very helpful.
