Just replaced an exciter in a JD 525. Starts fine but dies when I release the brake. Before I start to take things apart, what other than a bad brake switch could cause this? I wonder what I could have done to it while I worked on it. I replaced an exciter that was only 4-5 hours old. Could there be a relationship between the two problems? Would appreciate any suggestions. Thanks, Lloyd
Jd 525 stalling
- Thread starter lloydn
- Start date
- Views: 1136
beenthere
Super Star Member
- Joined
- Aug 16, 2001
- Messages
- 18,563
- Location
- Southern Wisconsin, USA
- Tractor
- JD_4x2_Gator, JD_4300, JD_425, JD_455 AWS, added JD_455, JD_110, JD_X485(sold)
Welcome to the forum.
Is the mower switch in the 'on' position, or is a wire off that the safety system thinks the PTO is engaged?
Is the mower switch in the 'on' position, or is a wire off that the safety system thinks the PTO is engaged?
Dutch445
Elite Member
seat switch
beenthere
Super Star Member
- Joined
- Aug 16, 2001
- Messages
- 18,563
- Location
- Southern Wisconsin, USA
- Tractor
- JD_4x2_Gator, JD_4300, JD_425, JD_455 AWS, added JD_455, JD_110, JD_X485(sold)
I think you are right Dutch. /forums/images/graemlins/wink.gif
