JD3320--Addition of a 4in1 bucket

[jbrandy]

I am looking for some advise. I have a 2005 JD3320 with a 300CX loader on it and have PBY kit installed. I am cosidering adding an additional bucket to my arsenal. I have found a used 4in1 bucket but it doesn't have the conrol valve or hoses. Where would I hook this up to to operate the grapple function. Can I use the PBY hook up? Any suggestions on setting up a control valve for this? Thanks for any input

 

[Willl]

I'd go with the JD 'third SV' kit (part # LVB25506)

It would be the cheapest and best looking IMO.

 

[Willl]

 

[gamble77]

That kit will work...best and most user friendly (although the most expensive...good things are always more expensive) is the kit from W.R Long.

 

[RollTideRam]

If you go with the Deere kit, go ahead and get the kit that runs lines from the rear scv to the end of the loader arms. I don't know the part number, but it cost about $300. JC