Re: jinma 204 3point hitch adjustment
Mark:
I used a 1/4" sheet metal screw welded to a 5/16" rod about 18" long. I noticed a hole about 1/4" in the end of the piston so i just screwed it in and pulled. Wham Bam and out she came. I had a the o-ring and the nylon spacers in my repair kit that i received with the purchase of my tractor but the size was about 2" inside and about 2 3/8 outside. 2 split nylon spacers and a o-ring. Looked pretty basic to me. I hope this helps. Dave
Mark:
I used a 1/4" sheet metal screw welded to a 5/16" rod about 18" long. I noticed a hole about 1/4" in the end of the piston so i just screwed it in and pulled. Wham Bam and out she came. I had a the o-ring and the nylon spacers in my repair kit that i received with the purchase of my tractor but the size was about 2" inside and about 2 3/8 outside. 2 split nylon spacers and a o-ring. Looked pretty basic to me. I hope this helps. Dave
