Jinma Model 6 Bed Blade

[VaGlock]

I purchased a new bed blade (anvil) for my model 6 Jinma chipper and the new blade has one beveled edge, the original has 2 flat edges. Contacted the seller and he stated to install beveled edge towards the chipper blades. Has anyone run into this before?

​

 

[Peter-Pieter]

It is obvious that the new blade you bought is not compatible with JINMA 6'' chipper. As a fixed blade, normally both sides of it are flat and can be replaced and used interchangeably.

 

[VaGlock]

I went ahead and installed it as Circle G Tractor Parts instructed me with the tapered side towards the rotating blades, set the gap to specs, They assured me it was the correct bed blade. After running some 2-3 inch branches through the chipper I was not pleased with the way it chipped, turned the blade around with the flat side towards the rotating blades and it chips a lot better. The original bed blade was broken and had to be replaced, so I just figured this was a updated blade. I know now that they sold me the wrong part even though it did fit.