Hello all, i have a JD 4430 that is leaking hydraulic fluid around the load control shaft. I removed the load control shaft, pictures attached. I am guessing that i need to buy a new shaft because of the ridges on the old shaft. The ridges are not deep, but may be enough to cause a leak. I am thinking that i will just replace the seals # 18, and #19 and not replacing the bushing #20. the bushing looks tight in the transmission housing. I really don't want to try to drive out bushing #20. what do you think?
also, is it critical to replace the #15 bushing, and #16 snap ring on the yoke #9? there is quite a lot of play between the load shaft/pin and the bearing in the yoke.
thanks for the help. Carr
also, is it critical to replace the #15 bushing, and #16 snap ring on the yoke #9? there is quite a lot of play between the load shaft/pin and the bearing in the yoke.
thanks for the help. Carr