Kasco front blade

[kennyd]

I am going to replace the control valve. The control levers are so close together you can put your hand around both at the same time. It makes it hard to just grab one.
Bill

That blade is very nice! Let me know when your ready to do that valve

 

[Hooked_on_HP]

I was surprised myself at how well every thing went. I bought this on ebay as a 5yr old never installed blade. I figured it would take a week or two. It was for a cub 7265. I wasn't sure how much fabrication I would have to do. All I had to do was drill 6-5/8 holes and add 11" to the brace that goes to the back. Every piece I needed came with it. The only other thing I had to buy was 2 male QD ends. I have never had this kind of luck.
Bill