philshel
Bronze Member
Thought I’d show my latest project. Picked up the hoe at auction for $2200 with a sub-frame. It is in good shape, all the pins are tight, just needs a new seat and so far one slightly leaky valve. The adaptation was fairly easy, I added a couple of cross-members to the sub-frame and bolt it to the tractor at the drawbar location. Added a couple of brackets to the loaders sub-frame for the front pivot point on the hoe’s sub-frame and that was pretty much it. I did build a crossbar type item that fits through a section of the hoe. I use it to lift the hoe into position with the lower 3-point arms, but it does help carry some of the weight if I leave it in the up position. The hoe has a simple hydraulic set up with just a in and a out which I will run off of my rear remotes. I plan to update the tractors main hydraulic pump to one of the newer higher volume models. However, I could not resist playing a little with it as is. It seemed to work well with the lower volume pump, could use a little more ‘umph’ but overall not bad.