Kioti CK35H New Owner Here

Dan513 · Feb 20, 2014

I just purchased a new CK35H but it is not currently at my occasion and I have a question. I am in the planning stage of adding work lights under the top side of the rop unit. I am not going to drill any holes into the rop unit for mounting the work lights, instead I am making mounting brackets out of steel bar stock. Does anyone know the measurements of the channel stock that the rop unit is made from? Width and depth?

rider7767 · Feb 21, 2014

Great tractor you have. Welcome to the forum. I used High output Stick On LED Light strips. They throw a lot of light and you want hit your head if you hit a big bump. My lights don't help much down the road, but they flood the work area around my tractor. My tractor is smaller, so you may have the room to mount without hitting your head. Again, welcome!

http://www.tractorbynet.com/forums/kioti-owning-operating/289456-video-new-led-lights-ck20s.html

Dan513 · Feb 21, 2014

Rider7767, thanks for you reply!

MotorSeven · Feb 21, 2014

Autozone...$30 for stick on's? That is a pretty good deal, I'll have to pick some up.

Sunnenman · Feb 26, 2014

Can you supply us with part numbers of everything you purchased to do your LED set-up? I want to add this to my tractor.
thx
sunnenman

rider7767 said:
Great tractor you have. Welcome to the forum. I used High output Stick On LED Light strips. They throw a lot of light and you want hit your head if you hit a big bump. My lights don't help much down the road, but they flood the work area around my tractor. My tractor is smaller, so you may have the room to mount without hitting your head. Again, welcome!

http://www.tractorbynet.com/forums/kioti-owning-operating/289456-video-new-led-lights-ck20s.html

seacap04 · Feb 27, 2014

Welcome to TBN. I welded a small piece of flat bar on the front side of the rops and mounted these on a DK45. I did drill and run the wires internal of the rops.