KL 1450 Loader

[DK35vince]

I checked my KL 1450 pressure relief valve setting a while back.
My tractor was delivered with the loaders relief valve set at 2250 PSI.
The loader owners manual calls for a maximum relief setting of 2300 PSI.
So I set my pressure at 2400 PSI.

 

[rback33]

I checked my KL 1450 pressure relief valve setting a while back.
My tractor was delivered with the loaders relief valve set at 2250 PSI.
The loader owners manual calls for a maximum relief setting of 2300 PSI.
So I set my pressure at 2400 PSI.

I didn't hear that... Honestly though...that aint hurting anything..lol

fiddleback... lol take it easy bro... it was an honest mistake and we all make them. Don't sweat it. What I should have said was that increasing the pressure would not gain you much given the geometry that it can affect (both cylinder and linkage).

 

[ToadHill]

To get back to the origional question grapevine asked, I have the 1450 loader and it has worked very well for me. I have over 90 hours using the loader to haul gravel from the stream gravel bed to build a pad. The loader will lift a full bucket of gravel and the only issue had been the tendency for the bucket to roll forward a bit as I crossed bumpy ground, but a slight tap to the control always corrected the situation.