Kubota L3540 hydraulic specs

[Tiger1vic]

Hi all. I've had my L3540 for a couple of years now but always found the hydraulics a bit weak and would like to check if the pressure is within spec. I've seen posts for other models here but have not yet found any that say what the pressure should be for my particular model. Does anyone have this spec handy and advice on where is the best place to measure it? Thanks!

 

[J_J]

If you have a loader, then you can install a 3000 psi hyd gage in the FEL IN/P port using a tee.

Don't know the exact pressure, but somewhere in the 2500 to 3000 psi area