L3010 & B2910 Weight and Height ?

Jeff_In_NC · Jan 7, 2001

If it misses by 5/8" there are a couple of tricks I've found to get it thru the door. At my old place the garage floor had a slight ramp going up into it (~4" rise). if I backed the tractor in the ROPS would clear the door jam but if I tried to drive straight in it lacked ~2" going thru.
At the new place the drive is level with the garage floor. It lacks ~1/2" going thru. I just raise the front wheels with the loader to tip it back a little and drive or back thru dragging on the bottom of the bucket with the front wheels raised.
jeff in nc

Bird · Jan 7, 2001

Yep, LarryT, I knew the folding ROPS was taller than my fixed one; just didn't know how much taller.

Bird

bcarter · Jan 8, 2001

My 2710 with a folding ROPS is less than 6ft tall with the ROPS folded. Its about 5in taller than my garage door opening with the ROPS up... found this out the hard way this weekend but fortunately didn't ding up the door trim too badly (dinged up my ego quite a bit though). /w3tcompact/icons/blush.gif

Bill