3-Point Hitch L3710 3 Point Hitch Hand Crank Problem

   / L3710 3 Point Hitch Hand Crank Problem #1  

lion12

New member
Joined
Jul 5, 2012
Messages
1
Location
Stowe, VT
Tractor
Kubota L3710
The hand crank on my L3710 used to rotate the 3 point hitch will only move a couple of turns. Has plenty of grease. Any suggestions on how to fix it? Thanks.
 
   / L3710 3 Point Hitch Hand Crank Problem #2  
maybe clean off the grease and see if the threads look damaged. Or the threaded part could be bent. I am dealing with a similar issue, where I actually removed mine and put in a vise to unthread completely so I could replace the thrust bearing in the gearbox. It was very difficult to do and I must have actually damaged the threads enough in this process that a couple months after putting it back together I actually had the threads pull out of the bottom part and the right side of my mower deck fell to the ground then when I lowered it I bent what was left of the threaded portion.
 

Tractor & Equipment Auctions

2010 Ford Edge SE SUV (A51694)
2010 Ford Edge SE...
2007 VOLVO VHD64 TRI AXLE DUMP TRUCK (A53426)
2007 VOLVO VHD64...
2018 DRAGON 130BBL VACUUM TRAILER (A53843)
2018 DRAGON 130BBL...
2006 International 4300 Water Tanker Truck (A52384)
2006 International...
2011 Wacker Neuson RD12A, 36" Double Drum Roller (A52384)
2011 Wacker Neuson...
(INOP) YAMAHA MOTO 4 ATV (A51247)
(INOP) YAMAHA MOTO...
 
Top