Leak at base of BH77

   / Leak at base of BH77 #1  

SilverState

New member
Joined
Sep 9, 2020
Messages
21
Tractor
Kabuta L2501
I've got plenty of power, but noticed a wet spot this morning when I spotted working then noticed what almost looks like grease but there's no grease point I know of there. Assuming it's hydraulic.
 
   / Leak at base of BH77
  • Thread Starter
#2  
20200927_161651.jpg
 
   / Leak at base of BH77
  • Thread Starter
#3  
20200927_161711.jpg
 
   / Leak at base of BH77 #4  
Looks like the nearest vertical valve in each of the photos has a slow leak, and is picking dust in the air .
 
   / Leak at base of BH77
  • Thread Starter
#5  
Looks like the nearest vertical valve in each of the photos has a slow leak, and is picking dust in the air .

I'm assuming that means to pull the entire spool valve and get in there for a real fix?
 
   / Leak at base of BH77 #6  
not always, start by just making sure all the hydraulic lines are snug, they do happen to loosen up over time every once in a while.
 
   / Leak at base of BH77
  • Thread Starter
#7  
not always, start by just making sure all the hydraulic lines are snug, they do happen to loosen up over time every once in a while.

Awesome, thanks, I'll wipe all that down and then snug it up. There's a few maintenance tasks I wanted to knock out anyway so I'll plan a day to get those all done. This is my first tractor, is it just wrench tight (tight but not snapping anything) or is it more specific than that?
 
   / Leak at base of BH77 #8  
If your going to end up taking apart to get to the rear, spray engine degreaser and rinse to remove as much dirt, dust and debris as you can.
When my BH77 was new I had to get to the back row by removing front row connections, and I had to get into the control stick to valve connection and thread lock/tighten the falling apart levers. I've never touched those things again in near 600 hours.
 
   / Leak at base of BH77 #9  
i'm sure there is a specific torque but I use common sense. if it is a tiny fitting don't put your whole body weight into it but if it is a large fitting you can lean into it a bit. go by trial and error. you can always add more torque if it still leaks but when the fitting breaks you know you have gone too far. JIC fittings are conical seats that seat together any dirt in between them can cause a leak.
 
   / Leak at base of BH77
  • Thread Starter
#10  
Terrific, thanks.
 

Tractor & Equipment Auctions

New/Unused Hydraulic Pallet Forks (A44391)
New/Unused...
2024 Greatbear Forklift/Skid Steer Jib (A44391)
2024 Greatbear...
Ryobi Expanded Capacity Table Saw with Rolling Stand (A44391)
Ryobi Expanded...
2011 Toro Z587L Z Master 72in Zero Turn Mower (A44572)
2011 Toro Z587L Z...
Year: 2011 Make: Nissan Model: Armada Vehicle Type: Multipurpose Vehicle (MPV) Mileage: 195,685 (A44572)
Year: 2011 Make...
2017 Chevrolet Express 2500 Cargo Van (A44571)
2017 Chevrolet...
 
Top