lever knobs
- Thread starter cheatmtn
- Start date
- Views: 1182
SimS
Gold Member
- Joined
- Oct 24, 2000
- Messages
- 486
- Location
- Rutledge, GA
- Tractor
- Kubota L3710DT, Case 1845C, Takeuchi TB015
cheatmtn;
Test the thread size using a nut that fits. After you determine what thread size you then need to visit McMaster and search for the knob(s) that you need. Works for me.
SimS
Test the thread size using a nut that fits. After you determine what thread size you then need to visit McMaster and search for the knob(s) that you need. Works for me.
SimS
RoyJackson
Rest in Peace
- Joined
- Nov 17, 2001
- Messages
- 23,144
- Location
- Bethel, Vermont
- Tractor
- John Deere 4052R Cab,, Deere 855D UTV, Z920A Zero Turn Mower and assorted implements
If you have a caliper or micrometer, measure over the outside diameter of the thread (this is called the Major Diameter).
Assuming the tractor is using American thread sizes, you can determine the thread.
Two examples: if you measure .312, it is a 5/16ths thread and probably a coarse thread so it would be 18 threads per inch. If you measure .375, it's a 3/8ths thread and probably 16 threads per inch. In a hardware store, you'd look for .3125-18 and .375-16 threaded fasteners. You might see these called out as fractional (5/16-18 or 3/8-16).
If you know the thread is metric, you'll have to convert unless your mic (or caliper) reads in metric as well as english. If you measure .394, multiply that by 25.4 which comes to 10.0076. Round that to the one decimel place and you'd know the thread is 10 mm. I'm not sure of the thread pitches, but they are measure by threads per millimeter so a 10 x.5 thread would be 10 millimeters in diameter and ½ threads per millimeter. That would be a pretty coarse thread.
Assuming the tractor is using American thread sizes, you can determine the thread.
Two examples: if you measure .312, it is a 5/16ths thread and probably a coarse thread so it would be 18 threads per inch. If you measure .375, it's a 3/8ths thread and probably 16 threads per inch. In a hardware store, you'd look for .3125-18 and .375-16 threaded fasteners. You might see these called out as fractional (5/16-18 or 3/8-16).
If you know the thread is metric, you'll have to convert unless your mic (or caliper) reads in metric as well as english. If you measure .394, multiply that by 25.4 which comes to 10.0076. Round that to the one decimel place and you'd know the thread is 10 mm. I'm not sure of the thread pitches, but they are measure by threads per millimeter so a 10 x.5 thread would be 10 millimeters in diameter and ½ threads per millimeter. That would be a pretty coarse thread.
