lift arm length

   / lift arm length #11  
I have a DX33 with a 5 ft KK. Since the pins on the KK are pretty high my tractor does not lift the implement very high. My lift arm has three pin holes to adjust with on the left side so I move to another hole to get the higher lift. Of course the right side is adjusted with the crank. Perhaps if your tractor has the extra holes you can restrict how high it lifts that way if necessary.
 
   / lift arm length #12  
If you don't want to go the cost or have them on there all the time (the quick hitch which would give you an inch or two) you could have extensions welded on the cutter to move the lift pins forward. Don't forget to be sure the pto shaft is still long enough.
 

Tractor & Equipment Auctions

2010 Ford Edge SE SUV (A51694)
2010 Ford Edge SE...
2018 Taylor-Dunn BigFoot B5-440-36 Electric Utility Cart (A50324)
2018 Taylor-Dunn...
1999 John Deere 670CH Articulated Motor Grader (A51691)
1999 John Deere...
2013 Crane Carrier Co. Low Entry Loadmaster Excel-S 25 Yard Rear Loader Garbage Truck (A51692)
2013 Crane Carrier...
2015 Ford Taurus Sedan (A51694)
2015 Ford Taurus...
41 stump Grab Bucket (A53421)
41 stump Grab...
 
Top