Loader bucket levelling aid

[Mendonsy]

I use pallet forks a lot too, so I have plenty of experience.

That's exactly why I added the second indicator to my setup. It makes it really easy to get the forks level when they are at a height where you can't see them (which seems to be more often than not).

 

[gwdixon]

I have an older L3650 with a LA650 loader that I like to have some type of a levelling aid so I know when my bucket is level. I was wondering if anyone has made or has an idea for this.
Thanks,
John

I had that exact tractor/loader combination.

On the top right side of the bucket is a 4" - 5" long piece of flat bar that is parallel to the bottom of the bucket. There should be (or used to be) a sticker on it that states it is the level indicator.

lreops has it right.

 

[john haylow]

I had that exact tractor/loader combination.

On the top right side of the bucket is a 4" - 5" long piece of flat bar that is parallel to the bottom of the bucket. There should be (or used to be) a sticker on it that states it is the level indicator.

lreops has it right.

Thanks for the replies. The bucket is not a Kubota. But I can see from all your replies a have a few options.
Thanks again,
John

 

[Lou66]

John,, This is the way mine is set up.. simple design,, you could paint the top of the tube stock,, but you will know when your bucket is level after about ten minute of use.. Lou

View attachment 290722View attachment 290723View attachment 290724View attachment 290725View attachment 290726

 

[john haylow]

Thanks Lou,
John