Loading and binding down the tractor to my Deck Over

   / Loading and binding down the tractor to my Deck Over #1  

Timber

Veteran Member
Joined
Jul 12, 2006
Messages
1,752
Location
East Bridgewater Massachusetts
Tractor
Kubota B7800
I have to move a shed for a guy tomorrow morning. It's a rather small building, I'm planing on lifting it a putting it on rollers and simply pushing it with th tractor
 

Attachments

  • image.jpg
    image.jpg
    481.3 KB · Views: 658
  • image.jpg
    image.jpg
    397 KB · Views: 320
  • image.jpg
    image.jpg
    478 KB · Views: 282
  • image.jpg
    image.jpg
    473.7 KB · Views: 334
   / Loading and binding down the tractor to my Deck Over #2  
That should do it! :thumbsup:

Joe
 
   / Loading and binding down the tractor to my Deck Over #4  
Hopefully that toolbox is very stout. Would it have been better to back on having the forks on the back? Lots of rocking forces going to the toolbox.
 
   / Loading and binding down the tractor to my Deck Over #7  
Looks good to me. The only thing that could shift might be the curl cylinders on the FEL, but I guess that would only tighten the strap across the forks maybe.

I would probably fold the ROPS, just because.
 
   / Loading and binding down the tractor to my Deck Over #8  
I trailered my JD 5103 / MX6 on a 22' GN around 10 miles and back a few months ago without fastening it down with anything. Just dropped the bucket and mower down, put her in Park and headed down the road :laughing:

(I couldn't find my straps and needed to get the mowing done... so I risked it on some back county roads.) I won't ever do that again, as I barely drove with my eyes on the road. They were mostly in the rear-view making sure my tractor wasn't moving! :laughing:
 
   / Loading and binding down the tractor to my Deck Over #9  
I would have put a strap on each rear wheel to take the load off the 3 pt hitch.
 
   / Loading and binding down the tractor to my Deck Over
  • Thread Starter
#10  
The chains and binders are the only things that have any real tension. The straps are just snug over the loader an brush cutter. There is no tension on the 3 point hitch as the mower is on the trailer deck. Most of the time I never strap them down whe they are attached to the tractor but the job I was doing was for a local cop
 

Tractor & Equipment Auctions

2014 UTILITY 53X102 DRY VAN TRAILER (A50046)
2014 UTILITY...
UNUSED Woven Landscape Fabric Rolls (A50860)
UNUSED Woven...
HARDEE AR-202 72" LANSCAPE RAKE (A50459)
HARDEE AR-202 72"...
New/Unused 2025 CFG QK20R Mini Excavator (A48837)
New/Unused 2025...
UPDATED INTERNET BUYER'S PREMIUM TERMS (A50774)
UPDATED INTERNET...
2007 AM General Corp M931A1 6x4 Truck Tractor (A48081)
2007 AM General...
 
Top