KiwiBro
Gold Member
Has anyone thought of or built something along these lines?
While the log forks/grapple has a log or logs, why not position it over a table or trailer and buck it into rounds without having to get off the tractor?
It would need a few arms/thumbs to hold the log/s, also a series of tongs (or pairs, about 8" apart) on the bottom and about six harvester bars or the like. The forks will pick up, say, 8' log lengths and buck into foot long rounds.
It would not be a cheap build, but is it possible? Not only would it be limited by my budget, but also the lift capacity of the FEL which will be around 3000 Lbs, and I suspect such an implement would not be light. Also, perhaps the hydraulic pump will limit how many bars could be run?
Any ideas? Anyone done such a thing? Would it work?
While the log forks/grapple has a log or logs, why not position it over a table or trailer and buck it into rounds without having to get off the tractor?
It would need a few arms/thumbs to hold the log/s, also a series of tongs (or pairs, about 8" apart) on the bottom and about six harvester bars or the like. The forks will pick up, say, 8' log lengths and buck into foot long rounds.
It would not be a cheap build, but is it possible? Not only would it be limited by my budget, but also the lift capacity of the FEL which will be around 3000 Lbs, and I suspect such an implement would not be light. Also, perhaps the hydraulic pump will limit how many bars could be run?
Any ideas? Anyone done such a thing? Would it work?