Loose loader bolts

[IslandTractor]

Make sure to check the bolts where the loader tower connects to the engine block. Those worked loose on my DK40se. I check annually and they've been tight for the last couple of years. I don't quite remember but I think I used blue Loctite when I reinstalled them. One had been lost before I recognized the problem. Need a torque wrench to get them tight. Torque value is in the maintenance manual which I don't have access to right now.

 

[Avondale]

Thanks for the recommendation. I have not applied anything yet as I assumed that in -20c to -30c, it may be tough for me to get it put on. Is there a temp level that this stuff needs to cure properly?

 

[GManBart]

Thanks for the recommendation. I have not applied anything yet as I assumed that in -20c to -30c, it may be tough for me to get it put on. Is there a temp level that this stuff needs to cure properly?

That varies by brand, strength, etc, but should be listed on the bottle.

 

[KiotiJason]

My dealer advised that it's the bolts stretching. I confirmed this as I put indicator marks on the nut and bolt to check for movement. After about 80 odd hours they settled down but I still check them. Also make sure you check the mounting bolts as well. I just nip them up and make sure I keep the greese up to the joints.

 

[Avondale]

Thanks, again. I have not bought the Locktite (yet) as we are suppose to stay below freezing for next 14 days (if you can trust the Weather Network 14 day trend)

 

[Fuggley]

Thanks, again. I have not bought the Locktite (yet)

You should avoid getting that stuff anywhere near plastic parts. Locktite will destroy plastic! Personally I don't trust Locktite in combination with nylon lock nuts and I prefer to just replace those if they wear out. I don't think it is supposed to destroy nylon though but it will dissolve most plastics so watch where you use it.