/ Mag drill, who has one, what brand, what do you do with oy and what brand of annular cutters do you use?
#41
OP
5030
Epic Contributor
- Joined
- Feb 21, 2003
- Messages
- 26,998
- Location
- SE Michigan in the middle of nowhere
- Tractor
- Kubota M9000 HDCC3 M9000 HDC
Use an annular cutter in a vertical mill? I don't see that as being at all useful except in a pinch and my vertical mills (I own 2), take Cat 1 tooling, not R8 and my collets are all ER (extended range), not 3 segment R8. The Cat tooling is all coolant through and I run only insert cutters.
As usual, getting off the main subject which is annular cutters in a Mag drill and again, I only use Hougen carbide tipped cutters that are compatible with the quick change spindle nose on my machine. Not cheap by a long shot but then quality and longevity never comes cheap.
As usual, getting off the main subject which is annular cutters in a Mag drill and again, I only use Hougen carbide tipped cutters that are compatible with the quick change spindle nose on my machine. Not cheap by a long shot but then quality and longevity never comes cheap.
